What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 27.06.2025 05:22
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
[image of Common-mode choke]
The MOV will conduct when the voltage exceeds 50% of line voltage.
Chevy Corvette Looking To Steal Mustang GTD Nurburgring Record: Report - The Drive
I post the exact comment here.
Barnstars:
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2 shot outside Minnesota high school graduation, suspect in custody: Police - ABC News
what exactly is a ‘surge’ protector?
In schematic diagrams this is the symbol for a fuse:
For this case there are devices called Metal oxide varistors (MOV).
2024–10–14 [Omar Gharbi Omar Gharbi ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What should I do if I love someone who does not love me?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Upvotes:
A fuse is a non-resetable over current circuit protector.
A new type of X-point radiator that prevents tokamaks from overheating - Phys.org
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
But… the neutral is now “floating” because of the 1 ohm resistance.
but I think this circuit , shows a few more pieces.
a photo is worth a thousand words.
The bolt then partially travels down the line to your home.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
At least they know the answer if they wanted it.
This Nutrient May Help Lower Your Stroke Risk by 36%, New Study Says - EatingWell
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
First Sentence:
These devices are installed between the “hot” and “neutral” and protective ground.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
At one ohm, the resistor has a maximum of 1 watt power.
5 foods to consume empty stomach to stabilize blood sugar levels naturally - Times of India
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
He then asserts :
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This one hit behind the barn.
What is lightning?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Navigating some of the thorny questions of estate planning - NPR
so, what happens?
(Dc diagram shown, AC is similar).
2024–10–10[John johnson John Johnson ]
Dog attacks on postal workers are the most they’ve been in 7 years - NBC News
eight
There are two important concepts here.
[old diagram got deleted by accident]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Why prostate cancer screenings matter — what Utah men should know - KSL News
Edit 2024–10.
The third is lightning and “how it gets conducted into a home.”
It seems Mohan does not understand the difference between a comment and an Answer.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
What does a fuse do?
nine
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
One is “what exactly is in a ‘surge protector’ ? ”
the problem then depends on "how fast does the fuse operate?".
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Because the load is inductive, the current lags the voltage.(by a bit).
It also is a device that limits the change in current flow.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where the MOV conducts again, and dissipated the energy.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
There are three different concepts here that are getting confused.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
He then describes Rainy Season and Lightning.
But it can get overloaded, and no longer works.
Here is a simplified AC power diagram.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is 'the assistant's answer'
2024–10–16 [ OO OLAOYE OYEBODE ]
An AC voltage/ current source, and an ac inductive load.
This device then solves the entire problem.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
One
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Now when you have a certain ac resistance, then a current flows in a loop.
These are simplified answers to the original question, and does not change anything I wrote above.
The other is “what does a “fuse” do?”
This is where this question deviates from being a 'generic' question, and becomes more specific.
but this device (an Inductor) … impedes the rapid changes in the current.
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then describes the function of a fuse.
A circuit breaker is similar, but is resettable.